Location：Home>Products>Water-based resin
水性树脂Bayhydrol AH XP 2754
水性树脂Bayhydrol AH XP 2754
Bayhydrol AH XP 2754
Characteristic data*
Property Value Unit of measurement Method
Non-volatile content
(1g / 1h / 125 °C, convection oven)
approx. 40 % DIN EN ISO 3251
Viscosity at 23 °C approx. 20 mPa·s DIN EN ISO 3219/A.3
pH approx. 7,0 DIN 53785
*These values are provisional. Binding supply specifications will not be availble
until the final product data sheet is published.
Other data**
Property Value Unit of measurement Method
Particle size approx. 110 nm
Minimum film forming temperature approx. 85 °C DIN ISO 2115
**These values provide general information.
Bayhydrol AH XP 2754
Properties / Applications Bayhydrol® AH XP 2754 is a primary styrene acrylic
dispersion to formulate one-component clear and
pigmented lacquers for single layer coatings and
topcoats. Coatings based on Bayhydrol® AH XP 2754
show excellent chemical resistance and very high
film hardness.
Bayhydrol® AH XP 2754 can be combined with polyurethane
dispersions or other acrylic dispersions, after checking
the specific product compatibility. Bayhydrol® AH XP 2754
is especially recommended for plastic coating application.
Storage • Storage in original sealed Bayer MaterialScience container.
• Recommended storage temperature: 5 - 30 °C.
• Protect from moisture, heat and foreign material.
General information:
The product is sensitive to moisture. Storage at higher
temperatures will result in increase of color
and viscosity.
Storage at significantly lower temperatures will result in
solidification. This solidification is reversible by
briefly heating the product without adversely affecting
the quality of the product.
Storage time Bayer MaterialScience represents that, for a period of
six months following the day of shipment as stated in the
respective transport documents, the product will meet the
values set forth in section "characteristic data" above,
provided that the product is stored in full compliance
with the storage conditions set forth in and referenced
under section "storage" above and is otherwise handled
appropriately.
The lapse of the six months period does not necessarily
mean that the product no longer meets the set values.
However, prior to using said product,
Bayer MaterialScience recommends to test such a product
if it still meets the set values.
Bayer MaterialScience does not make any representation
regarding the product after the lapse of the six months
period and Bayer MaterialScience shall not be responsible
or liable in any way for the product failing to meet the
set values after the lapse of the six months period
